Studied by 0 peopleAt the end of the day, it is important to clean the machine. When clearing the inside of the machine of chips, we jog the turret back and forth to clean the way covers, tools, and turret. What button do you press to jog the turret in the Z-axis?
Hand Jog button
When we turn a piece of material in a lathe, the cutting tool creates small pieces of metal, also known as_____.
Chips
terminal electrical component
A resistor is a passive two- ________ that implements electrical resistance as a circuit element.
If the coolant level is low, it is fine to add just straight water to fill up the tank......
34
current flow
In electronic circuits, resistors are used to reduce ________, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
ffff
At the end of the day, it is important to clean the machine. When clearing the inside of the machine of chips, we jog the turret back and forth to clean the way covers, tools, and turret. What button do you press to jog the turret in the Z-axis?
Hand Jog button
Practical resistors
________ as discrete components can be composed of various compounds and forms.
One
two minus one is
The mechanical device that is commonly found in a lathe to remove the chips is called a chip conveyor:
True
Before you leave the shop for the night, you should always prepare the machine for the following day's work.
True
If you are running material that creates long, stringy chips, it is best to run the chip conveyor less frequently. Large intervals between conveyor operation will help remove this type of chip.
False
The mechanical device that is commonly found in a lathe to remove the chips is called a chip conveyor:
True
It is a good idea to check the coolant level in the coolant tank before going home at the end of your shift.
Truee
Home
Note
Flashcard